JCI gas warning system f. hydrocarbons GD230-HC: 230V AC, IP21
More in this category: Warning systems
One click to the most important information:
Description
When power is turned on, a green LED will flash to indicate ready for operation.
The sensor warm-up process starts at the same time. After around four minutes, the green LED lights up and indicates “sensor active”.
The sensor is connected to a yellow and two red LEDs.
The yellow LED ...
When power is turned on, a green LED will flash to indicate ready for operation.
The sensor warm-up process starts at the same time. After around four minutes, the green LED lights up and indicates “sensor active”.
The sensor is connected to a yellow and two red LEDs.
The yellow LED indicates low gas concentration (alarm C) and the red LEDs indicate medium (alarm B) and high (alarm A) gas concentration respectively.
When gas is detected, the LEDs (2) illuminate and the relay for the corresponding alarm level changes its status. If an alarm delay has been set (see below), then the corresponding LED will first flash and, once the configured period has elapsed, will stop flashing and remain illuminated (and the relay status changes).
This product complies with the Low Voltage Directive 2006/95/EEC and the EMC Directive 2004/95/EEC.
Conforms with:
- EN 61 000-6-2:2001
- EN 61 000-6-3:2001
- EN 61 000-3-2:2001
- EN 61 000-3-3:1995
- EN 61 010-1:2001