Pego control box electronic 230V ECP 202 Expert with 2 NTC sensors

ECP 202 Expert (successor model to the ECP 200 Expert) is a microprocessor controlled cooling system controller for regulating room temperature, evaporator fan and defrosting heater. The actual temperature is shown on a three-digital LED display. The cooling system controller features five independent relay outputs for the compressor, evaporator fan, defrosting heater, alarm and room lighting. The ECP 202 Expert cooling system controller also features two isolated input contact (door contact switch and compressor protection) that can be configured. The state of each output is shown on the display. The cooling system controller is programmed using the buttons on the front panel. The ECP 202 Expert controller further features two NTC sensor inputs for reading the room and evaporator temperatures. Sensor breaks and short circuits are shown on the display.

Design:
Conforms with general regulations and standards such as
CE, EN 61000-6-1, EN 61000-6-3, EN 60335-1.
In pump down mode, the LP pressure switch is connected to the digital input
(terminal INP-1 and INP-GND). The solenoid is connected to the AUX / Alarm relay. Parameter AU is set to 4.

Features:

• 1x control board with display and keyboard as input controls

• 1x NTC sensor 10K 1% 1.5 m for room

• 1x NTC sensor 10 K 1% 3 m for evaporator

• Screw connections included

User note:

• The ECP Plus 202 Expert must be installed by trained technicians only.

• Modifications to the device can affect safety.

• Check type label for power supply information.

• The manufacturer assumes no liability where modifications or improper use has been made of the equipment.